Looking for turbine simulation templates? Sign up for SimScale and join the largest engineering simulation community in the world! | Page 1

This simulation aims to study the velocity and the tubulence inside a tubocharger

Experimenting the relation between the tip speed ratio of the turbine and the power coefficient of the turbine.

Simulation for 3D printed highbypass turbofan engine

using the micro wind  turbine to generate power

In this project, we will do the steady state incompressible fluid flow simulation of Archimedes Screw turbine. We will use many blade design iterations to find the optimum blade quantity and angles. Also the inlet velocity will be changed accordingly and its effect on the turbine forces would also be investigated in this work.

CFD Simulation of a spherical  helical turbine

Simulating the 4 inch diameter spherical helical turbine.

finding stall angle characteristics  of foil

Gorlov Helical Turbine for micro hydro application

Analysis of helical VAWT (vertical axis wind turbine) for urban rooftop installations.

test tidal bladeless turbine simulation for use in air and in water

To simulate if it will run in low wind speeds

Tutorial to simulate propulsion.
CFD.
To determine the possibilities of SimScale to simulate aerodynamic propulsion.

This investigation builds upon the current literature to investigate the performance effects of modifying the number of blades present within a cross flow micro hydro turbine.

Turbine type  Archimedes Screw
1 (No of helix)
No of blades 20
Head 1 m
Optimum angle 18 degree  referred from journal in internet
Length of the turbine shaft 3000
Geometry Details(dimension in mm)
Flow domain is cylinder dia (1200) length (3600)
MRF Volume cylinder dia(1100)  length(3400)
Turbine OUTER dia (1000) INNER dia(shaft dia) (400)
Total shaft length (3200)

Test to see if a idee makes a big differents

In this project incompressible fluid flow simulation of a conical draft tube is carried out. The parameters data is collected from the course book on fluid dynamics and the validation of CFD simulation result with the theoretical result is also performed. Steady state incompressible fluid flow simulation is selected for the given case.
The draft tube is a pipe of gradually increasing area, which connects the outlet of the water turbine's runner to the tail race. Draft tube helps to convert the exit velocity head into pressure or potential head.

Incompressible Tesla Pelton turbine Torque evaluation

This project  involves meshing a single-Shaft Turbofan Engine, and then simulating its' operation when facing an axial airflow of 150 m/s, while rotating with a velocity of 940 rad/sec (9000 rpm) . A Fan is used to bypass a large amount of air in the inside of the engine. For this case the typical Compressor, Combustion chamber and Turbine Stator were omitted, and only the Fan, Shaft, Shell and Turbine rotor were meshed and examined, in order to restrain the meshing requirements for complex, time consuming meshing and simulation.  A steady state incompressible flow simulation is executed to visualize the air flow through the components of the Turbofan, as well as the pressure and U magnitude distribution on the blades of the Fan and Turbine.

Link to  the extended compressible study (bigger domain included) : https://www.simscale.com/projects/fsite/turbofan_engine_extended_study/

turbine | SimScale Project Library | Page 1