Looking for pressure vessel simulation templates? Sign up for SimScale and join the largest engineering simulation community in the world! | Page 1

Attempting  to simulate the required bolt forces for gasket assembly stresses, operating gasket stresses, and deflections of relevant components.  Ultimately, the intent is to verify the acceptability of the design with spring washers.

Force applied by the tire internal pressure in the structure that the tire is mounted.

The goal of this project is to evaluate the effect of temperature in a pressure vessel before the collapse.

-Simulate the flow in a 1L submarine ballast tank when it is purged with 640psi compressed air.

This is a static structural analysis of a square pipe under internal pressure. The internal flow area is equal to that of an NPS 8 Schedule 40 pipe.

FEA calculation with used the symmetry. The geometry of the barrel with inside pressure.

This is a static structural analysis of an NPS 8 Schedule 40 for an internal pressure load.

CO2 cartridges state that they should not be heated in excess of 120F (49C), but are they actually safe at that temperature. What is the factor of safety. How much stress is exerted on the vessel at various temperatures as the CO2 liquid transforms to a supercritical fluid at 88F (31C). Can this information help the use of these seemingly innocuous devices. The goal is to determine the maximum allowable working pressure based on a partial liquid fill of a 16 gram CO2 assuming a FS of 1.2.

Attempt to model Expansion Vessel and evaluate suitability of Supports without reinforcement pads.

Analyzing stress in cylinder to hemispherical junction of  a pressure vessel.

to find out residual stresses in shrink fit
static analysis
shrink fit analysis with internal pressure to increase the strength of pressure vessel

pressure vessel | SimScale Project Library | Page 1