Looking for heat transfer simulation templates? Sign up for SimScale and join the largest engineering simulation community in the world! | Page 34

Heat flux analysis and temperature gradient

To increase the placement speed of the AFP

Predicting Window Fogging with SimScale CFD.

This is a conjugate heat transfer study in an electronics cooling project. With respect to the incoming air flow through the enclosed tunnel on the circular pin type heat sink design, and maximum component temperature, maximum power limit for the component was calculated.

First simulation of heat transfer on a LM7805

Checkin throw, flow rate and temperature profiles in a bridge

Convective Flow inside a Light Bulb is simulated.

Key Results:

1. Temperature distribution inside the light bulb

2. Behavior of flow due to convection

The aim of this project is to investigate the heat transfer through the assembly to get insights about the temperature distribution within the extruder

demonstrate the heat transfer in the pipe under the effect of conical turbulators

A heat generating object is kept in a container and filled with liquid. The heat transfer is to be calculated after sometime. What will be the maximum temperature  reached and in what time is also to be determined.

Simple 2D heat transfer model.  Learning how to use the software.

Case covered in the Academics Week of Mechanical Engineering - SAEM2018, Brazil. https://saem.unifesspa.edu.br/

To understand the types of heat transfer from a ladle carrying molten metal

effect of conical turbulators on flow in pipe

Cobb wall analysis if conduction for Earth Ship at Rams Without  Borders Pine Ridge site.

This small project demonstrates capabilities of CHT solver and highlights important things to keep in mind when running a CHT case.
The objective of this project is to  help the users to  become familiar to use the CHT solverimplemented in SimScale. In this case, two ducts, containing air and water, go through a Heat Exchanger made by Silicon and Steel.
We will be able to see how the heat gets exchanged through the different media, and how air and water behave differently when they go through this type of Heat Exchangers.
The simulation will be turbulent and the steady-state of this system will be simulated. No transient behavior was taken into account.

In this project, steady state thermal analysis of a CFL light bulb is performed.

This is a first test for a Rayleigh-Benard convection.

Examine the distribution of heat in a copper plate

To analyse the cooling and heat effect of the module at different temperatures

Conjugate heat transfer validation. Air flow over a plate is considered for this case. The setup of CFD model and comparative results are explained in SimScale forum comments section of this project.

In this project, thermal solvers of SimScale are validated by simulating high power LED packaging with different on sink placement.

Convective Heat Transfer application for room heating.

CHT simulation of heat sink with temperature source

My first Natural convection Simulation... Any thoughts on improvements please comment :) 

This project shows the thermal analysis of a LED with Insulated Metal Substrate - IMS - mounted on different heat sinks.

heat transfer | SimScale Project Library | Page 34