Looking for duct simulation templates? Sign up for SimScale and join the largest engineering simulation community in the world! | Page 2

Trying to design a Fan duct for a E3D V6 3D printing Hotend

Testing export from Revit to Simscale for a single round duct CFD

Make a comfortable room with Temperature is 25 degree celcius and relative humidity is about 50 percent

Silulating the air incompressible flux into a divergent duct

Using CFD to predicate pressure loss and improve HVAC design sequentially using CFD results.

Simulation Control Data forked from fp-023d

This project aims to obtain the airflow inside two design alternatives for an HVAC system of a theater room. Convective heat transfer simulation is used to obtain the flow pattern inside the room. Thermal comfort parameters such as PMV (Predicted Mean Vote) and PPD (Predicted Percentage of Dissatisfied) are obtained along with the mean age of fluid.

HPAC Webinar-Duct Flow Analysis and Design Optimization

The objective of this simulation is to become familiar with the fan-based Boundary Conditions implemented in SimScale. 
These Boundary Conditions create a  pressure drop on the face applied. This pressure drop depends on the flux going in/out through the surface, and they are related following the charasteristic curve of the fan.

Using this Boundary Conditions, different types of fans can be simulated behind the surfaces, and their effects on the different ducts can be estimated.

duct | SimScale Project Library | Page 2