Looking for cfd simulation templates? Sign up for SimScale and join the largest engineering simulation community in the world! | Page 195

Thermal simulation of MSI GF75 Thin 9SC cooling system

This project is an attempt to test Simscale capability to accurately predict Vortex Induced Vibrations (in terms of amplitude and frequency) of a cylindrical object placed in a stream of water.

computed fluid dynamics of a sphere in a rectangular domain - incompressible flow

Aerodynamic study of The 2022 F1 rear wing (Designed in accordance with the 2022 FIA Regulations)

Propeller study: Ethix-S3 5 inch 
For a Master thesis at BME GPK Áramlástan Tanszék (Budapest University of Technology and Economics, Faculty of Mechanical Engineering, Department of Fluid Mechanics)

Propeller study: Gemfan - 5152SR 5 inch 

For a Master thesis at BME GPK Áramlástan Tanszék (Budapest University of Technology and Economics, Faculty of Mechanical Engineering, Department of Fluid Mechanics)

Propeller study: Dalprop Spitfire T5148.5
For a Master thesis at BME GPK Áramlástan Tanszék (Budapest University of Technology and Economics, Faculty of Mechanical Engineering, Department of Fluid Mechanics)

Propeller study: Ethix-P3B 5 inch 
For a Master thesis at BME GPK Áramlástan Tanszék (Budapest University of Technology and Economics, Faculty of Mechanical Engineering, Department of Fluid Mechanics)

Propeller study: 4Plays Ummagawd 5 inch 
For a Master thesis at BME GPK Áramlástan Tanszék (Budapest University of Technology and Economics, Faculty of Mechanical Engineering, Department of Fluid Mechanics)

This tutorial project aims to showcase how to set up and run a simulation for a pump geometry. The subsonic meshing tool was used with coarse meshing.

Small mesh and study of efficiency

Minimal mesh and just two simulations to evaluate forces on a small propeller related to advance speed.

Tutorial on incompressible flow simulation for aerodynamics studies, using SimScale Standard mesh algorighm.

This tutorial project aims to showcase how to set up and run a simulation for a pump geometry. The Standard meshing tool was used.

cfd | SimScale Project Library | Page 195