SimScale simulation projects by scristo | Page 1

scristo's profile

The tutorial project is a sample Electronic cooling sink which consists of 3 solid regions and 1 fluid region. The solid regions are two FB-4 chips, which have a higher initial temperature and a heat sink over one of the chips. The air flows over the solid regions to remove the heat from it.

Tutorial project for a thermal analysis of a differential casing. The project only provides the geometry to start with. See our tutorials section to have a look at the step-by-step instructions to set up the simulation.

Tutorial project for linear static analysis of a crane

Tutorial project for a flow analysis of a pipe junction. The project only provides the geometry to start with. See our tutorials section to have a look at the step-by-step instructions to set up the simulation.

This  project analyzes the aerodynamics of a spoiler

Tutorial project for setting up the Automated Hex-dominant for internal flow for an angled pipe geometry.

Sample project for how to set-up the Hex-Dominant Parametric mesh for flow around a vehicle body.

Tutorial project for setting up a Multi-phase flow simulation

Tutorial project for a stress analysis of a connecting rod. The project only provides the geometry to start with. See our tutorials section to have a look at the step-by-step instructions to set up the simulation.

Mesh generation using hex dominant algorithm

Tet-Dominat Algorithm for mesh generation for pipe flow

Tutorial on creating mesh using tet-dominant algorithm

In this tutorial, a aerodynamic analysis of a F1 frontwing is presented. The flow around the wing is modeled as an incompressible, turbulent flow using a k-epsilon turbulence model. This tutorial is based on the first part of the SimScale F1 Simulation workshop series about aerodynamics.

Tutorial project for setting up the mesh using Hex-dominant automatic for external flow.

Public Profile

scristo's profile