SimScale simulation projects by rupole1185 | Page 1

rupole1185's profile

Tutorial project for a flow analysis of a pipe junction. The project only provides the geometry to start with. See our tutorials section to have a look at the step-by-step instructions to set up the simulation.

Internal pressure applied on pump housing - copy by @jdunne

This project conducts a dynamic analysis of a pinned bar under gravitational load

This project tests the durability of a skateboard when it impacts with a ground and bar

This project includes the shell and tube heat exchanger simulation using the conjugate heat transfer technique, abbreviated as CHT. Conjugate heat transfer defines processes which involve variations of temperature in solids and fluids due to thermal interactions.

This project shows the sliding of a rubber seal on a rigid body due to applied displacement.

A contact analysis of a consumer snap fit mechanism is analyzed in this project.

Analisi FEM passerella usata nel webinar CFD FEA SERVICE del 26/02/2018

This project shows a linear analysis of a multibody system restricted by bonded and sliding contact constraints.

In this project, impact analysis of a wheelie bin was performed hitting the rigid floor at initial velocity of 4 m/s i.e. drop height of approx. 1 m.

This project demonstrates a multiphase flow simulation of a waterfall.

Evaluate different types of snap joint: Cantilever, U-Shaped, Torsional and Annular

In this project a multiphase flow simulation of a stirred reactor is demonstrated.

f 11000
h 290
w 1715

Copied project from @aghakhani to set up a first run.

This project demonstrates the hip joint prosthesis for the femur bone. Several types of materials are tested for the hip joint in this case including Co-Cr-Mo on Ti-6Al-4V, Co-Cr-Mo on UHMWPE and Concrete on Concrete.

Model from @ysantos - brief static stress analysis using a bonded contact.

Public Profile

rupole1185's profile