Reference Pitot Tube Geometries for Pitot Modeling Project

About this project

I have uploaded 2 geometries of Pitot Tubes with blockages. These are expamples of the geometries we will use, and show how we will vary the geometries between differente iterations. 90 percent blocked with 5 mm protrusion is a more advanced geometry (we would like to go up to 99 percent) and 50 percent blocked 1mm is a more reduced blockage. the blockage percentage is determined as the ratio of inlet area vs blocked area (in our case a circle with 90 percent surface are as inlet area). Protrusion is the length this blockage extends past the static port entrance.