SimScale simulation projects by noahl310 | Page 1

noahl310's profile

Uploading 2 base pitot tube geometries from which the API should access to iterate simulation settings.

part of lower fidelity model of pitot with blockages

testing the velocity inlet table because the convergence plot looked wrong.

I have uploaded 2 geometries of Pitot Tubes with blockages. These are expamples of the geometries we will use, and show how we will vary the geometries between differente iterations. 90 percent blocked with 5 mm protrusion is a more advanced geometry (we would like to go up to 99 percent) and 50 percent blocked 1mm is a more reduced blockage.  the blockage percentage is determined as the ratio of inlet area vs blocked area (in our case a circle with 90 percent surface are as inlet area). Protrusion is the length this blockage extends past the static port entrance.

Testing compressible flow for pitot tube with varying mach number (up to 1).  Going to try to implement correct boundary and initial conditiosn to minimize error in the tests.

second round of defects. had issues recreating pitot tube failures with first round of defects.

Public Profile

noahl310's profile