SimScale simulation projects by johnsc28 | Page 1

johnsc28's profile

2.4mm Y with 1.6mm tubing, rotated so that inlet is on x-axis

Visualize combination of predominantly laminar flow in 2.4mm (nominal, actual ID 1.78mm) Y-fitting fed by 1.6mm (nominal, actual ID 1.58mm) tubing

Visualize flow in 2.4mm nominal (1.78mm actual ID) Y-fitting with 2.4mm nominal (2.38mm actual ID) under predominately laminar flow conditions

Tutorial project for a flow analysis of a pipe junction. The project only provides the geometry to start with. See our tutorials section to have a look at the step-by-step instructions to set up the simulation.

Gauge Tee with internal diverter 20 degrees from perpendicular to flow

Variation to see impact of inlet on X-axis rather than outlet

Public Profile

johnsc28's profile