SimScale simulation projects by itsavlidis | Page 1

itsavlidis's profile

Stress and Deformation on impeller blades

U type Baffled Heat Exchanger
Analysis type: Conjugate Heat Transfer
Highlights:
1. Pressure Drop of the coolant
2. Outlet temperature of the Hot gas and coolant
3. Surface temperature of the Shell

Check the pressure/Forces on a balloon structure

Simple project to show how to calculate Pressure Coefficient via a Field Calculator

This project shows the sliding of a rubber seal on a rigid body due to applied displacement.

Tutorial project for a flow analysis of a pipe junction. The project only provides the geometry to start with. See our tutorials section to have a look at the step-by-step instructions to set up the simulation. - Copy

Fun project for quick aerodynamic comparison of a Diamond shaped vs a Round shaped padel racket.

Engineering study of solar panels, including:

1. Wind loading and static structural analysis of a single panel

2. Transient wind analysis of a panel array

A simple example of the Thin Section mesh refinement control. Check this Forum Post for more details.

https://www.simscale.com/forum/t/thin-section-vs-sweep-mesh/96739

Shelf loading example

The aim is to design a shelf that can withstand certain amount of load.

Failure in this case can be assessed  by either:
(1.) Assessing the maximum stresses developed on the plastic shelf versus different loading conditions
(2.) Checking whether shelf bending might lead large deformations such that the shelf might fall off the mounts

Simple project studying NACA0012 symmetric airfoil under an angle of attack (aoa) range.

The workflow utilizes the parametric capabilities of SimScale to study multiple design points/multiple aoa.

Please check the following forum post for more information
https://www.simscale.com/forum/t/parametric-angle-of-attack-aoa-study-for-airfoil-lift-and-drag-calculation/96408

This is a sample project showing how to perform a bolt preload analysis on a bolted flange model.  
For this particular project, sweep mesh controls are utilized, in order to create better quality elements ensuring low total node count.

The project consists of a 45deg flange segment simulation as well as the full flange simulation model.

Public Profile

itsavlidis's profile