SimScale simulation projects by gurrala_bhargav | Page 1

gurrala_bhargav's profile

In this exercise, you will use linear static analysis to analyze several configurations of an aircraft engine bracket under a vertical load.

In this project the main aim is to analyze how the temperature and the heat flux distribution in a cooling plate affect the performance and efficiency of the  electric motor in a Formula Student race car and to check whether an optimized solution can be achieved

Incompressible Fluid Flow analysis of two globe valves

FSAE-Workshop Session-2 Homework project for aerodynamics of complete Formula Student Race Car

For step by step tutorial see: 
1. https://www.simscale.com/forum/t/step-by-step-tutorial-session-2-full-car-aerodynamics-part-1/78878
2. https://www.simscale.com/forum/t/step-by-step-tutorial-session-2-full-car-aerodynamics-part-2/79350

FSAE workshop session 1-Front Wing Analysis homework tutorial project.
For Step-By-Step see: 
1. https://www.simscale.com/forum/t/step-by-step-tutorial-session-1-front-wing-design-study-part-1/78755
2. Tutorial part 2: https://www.simscale.com/forum/t/step-by-step-tutorial-session-1-front-wing-design-study-part-2/79155

The project gives the insight of how the lift and drag forces  at different angles has their effect on the performance of the airplane

The objective of this project is to how an aircraft wing structure behaves when it is subjected to bending and torsional load under wind pressure under static structural type of simulation

In this exercise, we will consider the deflection of a cantilever beam with a concentrated load at the free end. We can calculate the deflection by hand and via a static analysis using the SimScale platform.

In this exercise, you will perform a simple heat transfer analysis on the SimScale Platform and then compare the results to a hand-calculated solution.

In this exercise, you will complete a laminar pipe flow analysis

Tutorial project for a stress analysis of a connecting rod. The project only provides the geometry to start with. See our tutorials section to have a look at the step-by-step instructions to set up the simulation.

Public Profile

gurrala_bhargav's profile