SimScale simulation projects by douaastt20 | Page 1

douaastt20's profile

The goal of the project is to optimize the design of an F1 Rear wing. An incompressible flow simulation will be used with a speed of 10m/s (36km/h) at the inlet and on the floor. 

F1 Rear wings are designed to create more negative lift on the car by deflecting the incoming air and creating flow separation. This serves to reduce the amount of drag experienced by the vehicle which allows to it move faster in a given distance than a vehicle that doesn't possess one. 

Feel free to correct me where I have done wrong and let's discuss this case together! Happy Simulating! - Copy - Copy

The goal of the project is to optimize the design of an F1 Rear wing. An incompressible flow simulation will be used with a speed of 10m/s (36km/h) at the inlet and on the floor. 

F1 Rear wings are designed to create more negative lift on the car by deflecting the incoming air and creating flow separation. This serves to reduce the amount of drag experienced by the vehicle which allows to it move faster in a given distance than a vehicle that doesn't possess one. 

Feel free to correct me where I have done wrong and let's discuss this case together! Happy Simulating! - Copy

Tutorial project for a flow analysis of a pipe junction. The project only provides the geometry to start with. See our tutorials section to have a look at the step-by-step instructions to set up the simulation.

Public Profile

douaastt20's profile