Conjugate Heat Transfer (legacy)

Conjugate heat transfer (legacy) has been replaced by Conjugate Heat Transfer v2.0 and will shortly no longer be available for use. You can only see it here as you have been granted access based on an exceptional condition. Therefore we strongly recommend to use CHT v2.0 as a default and consult with your simscale support staff if you feel Conjugate Heat Transfer (legacy) is required for your application. | Page 98

Tubos: Oxigeno liquido a -182C
Coraza: agua de 32C a 5C

First attempt at small scale water cooling loop.

The said project is  a container to hold 4 test tubes of 5ml capacity at a low temp for long durations.

It is impossible to make a working geometry

Simple parallel flow heat exchanger using FreeCAD and SimScale. Results show hot stream cooling and cold stream heating up, as expected. This was my first success at getting heat exchanger to work with SimScale. Trick was getting the two fluid volumes extracted correctly. SimScale is so far very encouraging - very easy to use. I will try to post a heat exchanger tutorial.

Etude de l'efficacité d'un échangeur double flux

Reintroducing the thin-walled box, with a couple of vent holes

Conjugate Heat Transfer (legacy) | SimScale Project Library | Page 98