Conjugate Heat Transfer (legacy)

Conjugate heat transfer (legacy) has been replaced by Conjugate Heat Transfer v2.0 and will shortly no longer be available for use. You can only see it here as you have been granted access based on an exceptional condition. Therefore we strongly recommend to use CHT v2.0 as a default and consult with your simscale support staff if you feel Conjugate Heat Transfer (legacy) is required for your application. | Page 88

CHT Simulation - V10 with reduced fin height and same Gap

Started with V10, but reduced the number of fins from 10 to 8 - CHT Simulation

Heat transfer enhancement using twisted tape and wire coil inserted in a tube.

Revision of V6 design, increasing the oil tank width (y) by 0.25 in. to 5.25 in.  CHT simulation

CHT Simulation - Increased enclosure width of V4 by 0.25 in.

Design a heatsink and perform thermal analysis

Repeat calculation with reduced cover height of 4 in.

CHT simulation with number of fins reduced by 50 percent

Conjugate Heat Transfer (legacy) | SimScale Project Library | Page 88