Conjugate Heat Transfer (legacy)

Conjugate heat transfer (legacy) has been replaced by Conjugate Heat Transfer v2.0 and will shortly no longer be available for use. You can only see it here as you have been granted access based on an exceptional condition. Therefore we strongly recommend to use CHT v2.0 as a default and consult with your simscale support staff if you feel Conjugate Heat Transfer (legacy) is required for your application. | Page 71

Powertrain cooling with battery split into 10 modules, spaced 25mm

CHT Simulation expanding on V16 with the addition of 4 heat sources

A learning project for testing a enclosed 3D printer.

Same as with Fluid, but verifying difference in numbers

- What is the project goal
The project goal is to simulate the three basic modes of heat transfers occurring on a radiator: Conduction through the tube walls, Convention due to water flowing in the tubes and the second convection caused by the air flowing through the radiator.

-Simulation type
Because of the heat transfer between the solid of the radiator, and the fluid flowing inside, the chosen simulation type is the Conjugate Heat Tranfer.

-Project details
The fluid that is flowing through the radiator is water. It enters the radiator at 40 degrees celsius at a flow rate of 2.8 kg/s.  The air flowing outside the radiator is at an ambient temperature of 19.28 degrees celsius, moving at 0.5 m/s.

Simulation assuming natural convection inside

CHT Simulation - Heat sink with multiple Components

trying isolation over walls to reduce heat loss

Conjugate Heat Transfer (legacy) | SimScale Project Library | Page 71