Conjugate Heat Transfer (legacy)

Conjugate heat transfer (legacy) has been replaced by Conjugate Heat Transfer v2.0 and will shortly no longer be available for use. You can only see it here as you have been granted access based on an exceptional condition. Therefore we strongly recommend to use CHT v2.0 as a default and consult with your simscale support staff if you feel Conjugate Heat Transfer (legacy) is required for your application. | Page 16

The goal of the project is to gain an understanding of a heat sink's ability to dissipate heat generated from an electrical device in a PC. A Conjugate Heat Transfer (CHT) simulation will be used to model the system. A plate fin heat sink is placed on an electrical device within a PC housing. Air flow from a fan blows over the heat sink and exits through vents.

Simulation of air blowing inside a PC box

Heat sink Simulation for Heat Transfers Assignment.

Simulation based on CHT-Heat Skink and Chip but with a tweaked gravity domain

Heat transfer analysis of a pin fin heat sink for application in CPU chip cooling

Heat exchanger with stainless steel radiating rings

to investigate the effectiveness of heat exchange between the concentric tanks.
I will be using conjugate heat transfer.

Simplified Heat Exchanger for ice cream flow

This project aims to showcase the different configuration options for the standard meshing tool, including basic and advanced settings. The various refinements are also covered.

Conjugate heat transfer simulation tutorial.

Thermal_Management_Electronics_Box_Forced_Convection

Conjugate Heat Transfer (legacy) | SimScale Project Library | Page 16