SimScale simulation projects by alexmf | Page 1

alexmf's profile

Tutorial for Static stress analysis of Underrun protection device

Tutorial project for linear static analysis of a crane

Tutorial project for a stress analysis of a connecting rod. The project only provides the geometry to start with. See our tutorials section to have a look at the step-by-step instructions to set up the simulation.

This tutorial shows how to analyze the Heat transfer in a heat sink.

Tutorial project for heat transfer in an engine piston

Tutorial project for a thermal analysis of a differential casing. The project only provides the geometry to start with. See our tutorials section to have a look at the step-by-step instructions to set up the simulation.

The tutorial project is a sample Electronic cooling sink which consists of 3 solid regions and 1 fluid region. The solid regions are two FB-4 chips, which have a higher initial temperature and a heat sink over one of the chips. The air flows over the solid regions to remove the heat from it.

Tutorial project with the goal of simulating the wave effects on a boat.

Tutorial project for setting up a Multi-phase flow simulation

Sample project for how to set-up the Hex-Dominant Parametric mesh for flow around a vehicle body.

Tutorial project for Aerodynamic simulation of compressible flow over Airfoil

In this tutorial, a aerodynamic analysis of a F1 frontwing is presented. The flow around the wing is modeled as an incompressible, turbulent flow using a k-epsilon turbulence model. This tutorial is based on the first part of the SimScale F1 Simulation workshop series about aerodynamics.

Tutorial for In-compressible Turbulent flow through a cyclone seperator

This  project analyzes the aerodynamics of a spoiler

Tutorial project for a flow analysis of a pipe junction. The project only provides the geometry to start with. See our tutorials section to have a look at the step-by-step instructions to set up the simulation.

Tutorial project to set up the Hex-dominant Parametric mesh for rotating geometries. This mesh can then be used for MRF and AMI simulations that incorporate rotation effects.

Public Profile

alexmf's profile