SimScale simulation projects by TejasPandey | Page 1

TejasPandey's profile

In this exercise, we will consider the deflection of a cantilever beam with a concentrated load at the free end. We can calculate the deflection by hand and via a static analysis using the SimScale platform.

This project is the starting point for the homework for Session 1  of  the Baja SAE workshop. It enables the user to analyse the plastic deformation in an All Terrain  Vehicle (ATV)  Suspension .

dfmnlsdfnlwekfk wef wle jfwej fiowef woef oweifwe f

Incompressible Fluid Flow analysis of two globe valves

The goal of the project is to optimize a globe valve

In this exercise, you will complete a laminar pipe flow analysis

In this exercise, you will perform a simple heat transfer analysis on the SimScale Platform and then compare the results to a hand-calculated solution.

This tutorial project aims to showcase how to set up and run a simulation for a pump geometry. The Standard meshing tool was used.

Tutorial project for a flow analysis of a pipe junction. The project only provides the geometry to start with. See our tutorials section to have a look at the step-by-step instructions to set up the simulation.

Tutorial project for a stress analysis of a connecting rod. The project only provides the geometry to start with. See our tutorials section to have a look at the step-by-step instructions to set up the simulation.

Public Profile

TejasPandey's profile