SimScale simulation projects by Sergi_S | Page 1

Sergi_S's profile

Simulation as 3.3 but with 5 tubes with 20 mm diameter. The tray and tube contacts surface separations is 50 mm.

Simulation as 3.3 but with only a tube with 50 mm diameter.  The tray and tube contacts surface separations is 50 mm.

Simulation as 2.1 but adding some more tubes and changing their diameter from 20 mm to 10 mm. These tubes are separated 80 mm

Simulation as 2.1 but with only a tube and changing their diameter from 20 mm to 50 mm. These tubes are separated 80 mm.

Test with a mould and a tubes of cooling water

Tutorial project for a flow analysis of a pipe junction. The project only provides the geometry to start with. See our tutorials section to have a look at the step-by-step instructions to set up the simulation.

Public Profile

Sergi_S's profile